LG Therma V R290 Monobloc (SG Ready)

← Verwarming

Modbus connection to LG Therma V heat pump. Uses SG Ready energy states for intelligent control. Set the indoor unit in the installer settings > "Connectivity" > "Energy state" > "ESS use type" > to "Modbus". Since the internal power measurement shows too high values, an external power measurement is suggested. Factory setting Modbus (HEX) = 21 (33). Modbus registers can be found within the installation manual (address without the leading number and -1). Information on the energy state can be found within the installation manual. Energy states 6 and 7 can be adapted at the indoor unit in the installer settings > "Connectivity" > "Energy state" >"Energy state definition". If the internal power measurement does not work (not all models support this register), please set energy metering to "false".

Ondersteunde functies

• Dimbaar: Het opgenomen vermogen kan worden verlaagd (bijv. § 14a EnWG). Zie Externe limiet.

Parameters

Modbus

SerieelNetwerk

Naam	Omschrijving	Waarde	Niveau
id	Modbus-ID Standaard: 1	int	verplicht
device	Apparaatnaam USB-RS485-adapter Voorbeeld: /dev/ttyUSB0		verplicht
baudrate	Baudrate Standaard: 9600	12009600192003840057600115200	verplicht
comset	ComSet Communicatieparameter voor de adapter Standaard: 8N1	8N18E18N2	verplicht
host	IP-adres of hostnaam Voorbeeld: 192.0.2.2		verplicht
port	Poort Standaard: 502	int	verplicht
tempsource	DHW warm water tank or inlet flow temperature Standaard: water_tank	water_tankwater_inlet	optioneel
energystate	SGReady states or modifyable energy state 6 and 7 Standaard: SGReady	SGReadyIndividualEnergystate	optioneel
haspower	Internal energy metering Standaard: true		optioneel

Configuratievoorbeeld voor evcc.yaml

Als u niet via de gebruikersinterface wilt configureren, kunt u ook dit YAML-blok gebruiken.

chargers:
    - name: my_heating
      type: template
      template: lg-therma

      # RS485 via adapter (Modbus RTU)
      modbus: rs485serial
      id: 33
      device: /dev/ttyUSB0 # USB-RS485 Adapter Adresse
      baudrate: 9600 # Prüfe die Geräteeinstellungen, typische Werte sind 9600, 19200, 38400, 57600, 115200
      comset: "8N1" # Kommunikationsparameter für den Adapter

      # RS485 via TCP/IP (Modbus RTU)
      modbus: rs485tcpip
      id: 33
      host:  # Hostname
      port: 502 # Port
      tempsource: water_tank # DHW warm water tank or inlet flow temperature, [water_tank, water_inlet]
      energystate: SGReady # SGReady states or modifyable energy state 6 and 7, [SGReady, IndividualEnergystate]
      haspower: true # Internal energy metering