my-PV AC•THOR

← Riscaldamento

Use the local web interface of AC•THOR to set the value "Power timeout" to a value slightly higher (e.g. + 5s) than the interval time of evcc. Use control type "Modbus TCP" and set loadpoint minimal current to 0.125A. If the heating element at the controlled output has < 9 kW, the scaling factor has to be calculated as follows: scale = 9000 / nominal power of the connected heater.

Operation mode M3: 9 + 9 kW with an additional heater connected to the relay output is supported. Without load measurement using my-PV meter, the "Load at relay" setting in the local web interface of the AC•THOR must be set to match the nominal power of the heating element at the relay. If the heater at the controlled output has < 9 kW, AC•THOR firmware a0022401 or higher is required and the value for "Load at relay" must be converted using the scaling factor as follows: Load at relay = nominal power of the heater at the relay * scale factor

Funzionalità supportate

Contatore integrato: Supporto per un contatore integrato.

Parametri

Nome	Descrizione	Valore	Livello
`id`	ID Modbus Predefinito: `1`	int	obbligatorio
`host`	Indirizzo IP o hostname Esempio: `192.0.2.2`		obbligatorio
`port`	Porta Predefinito: `502`	int	obbligatorio
`tempsource`	Temperature source Predefinito: `1`		facoltativo
`scale`	Scale factor for power target value Predefinito: `1`		facoltativo

Esempio di configurazione per evcc.yaml

Se preferisci non configurare il dispositivo dall’interfaccia, puoi usare questo blocco YAML.

chargers:
    - name: my_heating
      type: template
      template: ac-thor

      # Modbus TCP
      modbus: tcpip
      id: 1
      host:  # Hostname
      port: 502 # Port
      tempsource: 1 # Temperature source, [1, 2, 3] (optional)
      scale: 1 # Scale factor for power target value, optional