NIBE Nibe S-Series (SG Ready)

← Opvarmning

Modbus connection to the NIBE S heat pump. Firmware version 4.7.5 or newer is required. Required settings in the control unit:

In the indoor unit, Modbus must be enabled in menu 7.5.9
To use power control, “external power limitation via Modbus” must be selected under AUX in menu 7.4. In the charging point settings, a minimum power of 1.2 kW (single-phase) must be configured. If the base load is higher, it must be set as the minimum power.
In menu 7.4, the options “SG-Ready A” and “SG-Ready B” must not be assigned.
The value 1 (uint8) must be written once to holding register 3032.

Understøttede funktioner

Kan nedreguleres: Effektforbruget kan reduceres (f.eks. § 14a EnWG). Se Ekstern grænse.

Parametre

Navn	Beskrivelse	Værdi	Niveau
`id`	Modbus-ID Standard: `1`	int	påkrævet
`host`	IP-adresse eller værtsnavn Eksempel: `192.0.2.2`		påkrævet
`port`	Port Standard: `502`	int	påkrævet
`tempsource`	Temperature sensor Standard: `water_mid`		valgfri
`powercontrol`	power limitation Standard: `true`		valgfri

Konfigurationseksempel til evcc.yaml

Hvis du ikke vil konfigurere via webgrænsefladen, kan du i stedet bruge denne YAML-blok.

chargers:
    - name: my_heating
      type: template
      template: nibe-s-series

      # Modbus TCP
      modbus: tcpip
      id: 1
      host:  # Hostname
      port: 502 # Port
      tempsource: water_mid # Temperature sensor, [water_top, water_mid]
      powercontrol: true # power limitation

Se nightly-versionen